Now on to today's fun double slider card! To create this card, you will need to start with a card base measuring 5 1/2" x 8 3/8". I used Coastal Cabana as my card base. You will then score this with the long edge to the top at 1/4"; 3" and 5 3/4". Then, using the Classic Label punch, take a "snip" from the top and bottom of the panel created with the 5 3/4" score line. This is going to create the slider area.
Next, wrap a piece of plastic approximately 12" x 1 3/4" around the panel you created the 'notches' and using Tear & Tape, seal the plastic in a loop around the panel. It should nest inside the notches you punched with the Classic Label punch.
Now cut 2 panels of Coastal Cabana measuring 2 1/2" X 4 3/8" and 2 panels of Whisper White 2 5/16" x 4 3/16" and decorate with your stamps and ink. Now the image you want to rise to the top, add a couple of glue dots to the bottom front of the image panel and lay face down onto the plastic piece. Be sure the image is adhered only to the plastic loop and not the card base at all otherwise your image won't slide. Now, adhere the image that will slide down, to the front of the plastic loop with glue dots to just the top of the image on the back. Punch a hole in the bottom and tie a piece of ribbon to create a pull. Next add Tear & Tape down the 1/4 fold and adhere the card shut.
To complete the card, I added a piece of DSP to the front measuring 2 3/4" x 5 1/4" and stamped my Hot Air Balloon and punched it for the front.
I truly hope you enjoyed today's card. It was a lot of fun to make and I hope it inspires you to try it out as well. If you enjoy cards such as this, and would like tutorials direct to you inbox, then be sure to join my mailing list here.
Happy Stamping,
Product List
No comments:
Post a Comment